Where to glue the AXN engine mounting?

If you didn't have to build it then you can talk about it here.

Re: Where to glue the AXN engine mounting?

Postby BillGriffiths100 » Wed Jun 13, 2012 7:54 am

quarry44 wrote:If you have a severe ding in the leading edge,you can always cut a square piece out around the ding.Then get a piece of spare foam(packing),cut a bit bigger than the piece you previously cut out,and glue in with gorilla glue or WHY,and let dry overnight.Next day,using very fine sandpaper(180 or higher),sand the repaired section back to wing shape.It'll be barely visible.

Hey, just what I was going to say, but to add to that you can use the clear parcel tape to wrap around the profile afterwards to seal the surface.
Compromising with out of control government is like living with a lion, sooner or later the bloody thing will eat you .

You accept the tyranny of the state when it's not being applied to you, when it is: it's too late.
User avatar
Posts: 553
Joined: Mon Sep 20, 2010 2:04 pm
Location: London UK

Re: Where to glue the AXN engine mounting?

Postby cynr100 » Wed Jun 13, 2012 8:49 am

This is a good demonstration of just how much an AXN can bear:


Thanks to Bruce and the dudes at SWMAC, is it still flying :?: :?: :D :D 8-)
Not enough time in the day for all my crazy ideas, I'm not slow, I'm just pacing myself
User avatar
Posts: 821
Joined: Wed Jan 25, 2012 7:37 am
Location: Cairns, Australia

Re: Where to glue the AXN engine mounting?

Postby Andre » Wed Jun 13, 2012 8:57 am

Thanks - I'll remember that for the future - this one is not big enough to warrant it. When I get a big ding, I'll do all the dings...
Posts: 35
Joined: Sun Jun 03, 2012 10:52 am
Location: Wellington, New Zealand


Return to ARF and RTF Models

Who is online

Users browsing this forum: No registered users and 1 guest