Page 1 of 1

Naze32 motor 2

PostPosted: Mon Jul 06, 2015 10:27 am
by FPVspy
Hi. I have built the 250 cheep version that Bruce put on youtube but I have a problem motor 2 spins up faster than the rest when using my tx. I have set the ESC's as per the youtube vid 14 times and all though when I use Baseflight software all 4 motors work perfectly. but when I use my tx number 2 motor flys up faster than the rest and I am comply overwhelmed as to why.

Any help or guidance would be appreciated.

Re: Naze32 motor 2

PostPosted: Wed Jul 08, 2015 6:21 pm
This will be a process of elimination. Fist remove props, unplug lead for motor 2 and say motor 4 and swap them around at the Naze board. Test run motors. If the fault has now moved to motor 4 then it's a fault with the Naze board. If it's still motor 2 that's at fault then it's ether the motor or ESC in that case you will have to swap the motor for another and test again.
I hope I haven't confused you, when I refer to motor 2 i mean the one that started off as front right and motor 4 started as front left.
If I had to make a guess I'd go for the ESC as being the culprit.

Also check the subtrims on your transmitter. Are they all set to zero?

Good luck