Dielectric compound

If you've got a problem then you can ask here and either I or others will likely come to your rescue.

Dielectric compound

Postby beau0090_99 » Wed May 05, 2010 2:39 pm

I have a Hitec servo that I have been having problems with (very glitchy-lots of stops and starts). I took it apart and it seemed like it might be an intermittent short between signal and ground (HS-311). I pulled the lead away from the ground plane and put the servo back together and it runs smooth as silk. I want to go back in there and see if I can put some material between the lead and the ground plane, but not sure. I want it to be a liquid, because it is a very small area. Would hot glue be enough of a dielectric to insulate against 5v? Any other ideas? I want to use something that I have around the house.
Thanks,
Curtis
User avatar
beau0090_99
 
Posts: 28
Joined: Tue May 04, 2010 7:09 pm
Location: Eden Prairie, MN, USA

Re: Dielectric compound

Postby RCModelReviews » Wed May 05, 2010 7:10 pm

Hot glue is an excellent insulator at these low voltages but if I were you I'd use a magnifier to see if I can spot exactly where the short is occurring -- that's the only way you'll know for sure that you've fixed it and that it's not some other intermittent problem.
RCModelReviews.com, just the facts.
User avatar
RCModelReviews
 
Posts: 2120
Joined: Tue May 04, 2010 3:40 am


Return to Help Needed

Who is online

Users browsing this forum: No registered users and 1 guest

cron