turnigy 9x stick malfunction

If you've got a problem then you can ask here and either I or others will likely come to your rescue.

turnigy 9x stick malfunction

Postby CentralOregon » Wed Jan 12, 2011 7:53 pm

the right stick in the front to back motion quit working - no responce from servo connected to that channel - side to side still works and left stick still works - changed out servo- switched modes - anybody else have this problem?- anu ideas??
Posts: 2
Joined: Wed Jan 12, 2011 2:48 pm

Re: turnigy 9x stick malfunction

Postby RCModelReviews » Thu Jan 13, 2011 4:31 am

Could be either a faulty pot, faulty wiring to the pot or a faulty microcontroller.

Start by checking the wiring to that stick unit -- make sure the soldered joints look good and that the connector which is on the other end of those wires is firmly pressed into the circuit board.
RCModelReviews.com, just the facts.
User avatar
Posts: 2120
Joined: Tue May 04, 2010 3:40 am

Return to Help Needed

Who is online

Users browsing this forum: No registered users and 3 guests