RC Model Reviews

Hi guys,

I've built a Copterx 450 AE V2 and something is causing a lot of vibration. All I see is that the main gear is thrashing all over the place and the rotorhead looks as if it was bent (while running). I put in a HobbyKing main gear I changed the main shaft and rotor head and still there's this vibration, and I still don't know what's causing it.
What can I do?

Have you checked to see that the blades are balanced?

RCModelReviews wrote:Have you checked to see that the blades are balanced?

align tracking, balance the head, balance the tail blades ... http://www.heliguy.com/Forum/

Thx for your response, it turns out that the stock ESC is causing most of my problems I tried it with a 30A ESC and it runs like nobody's business but it's way too small for a 450 heli. What's a good ESC for a 450 size heli?

Looks like it comes with a 50A
there may be something wrong with your motor, start checking for binding if everything is balanced

http://www.hobbyking.com/hobbyking/stor ... duct=10941

those are pretty decent
although the governer somtimes does seem to go a bit bezerk and takes a while to figure out how to lock onto the correct speed again