Need help setting up ESC
Posted: Fri Apr 27, 2012 9:51 pm
I have T-rex 450 clone with the Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2) (v2 Firmware),Flymentor 3D helicopter stabilisation System and H-King 60A Brushless Speed Controller. I can get the servos to work fine,but the motor won't run. I've tried the motor on another Helicopter and it works fine. The throttle shows its working in the display and tried re calibrating the Tx levers. Not sure where to go next? The esc won't recognize the tx throttle.