Antenna wire question

Problems, experiences or just something to say about RC gear? Say it here.

Antenna wire question

Postby entomophile » Sat Dec 24, 2011 5:39 am

Antenna wire is coax so the shield and the signal wire should be electrically isolated, correct? I am having radio problems that I think I traced to my TX module. If I put my multimeter probes on the two solder points for the coax wire on the TX circuit board, it tells me they are electrically connected. Am I correct in thinking my TX module circuit board has a short? It is a FlySky (Turnigy 9x) TX. The board looks as if it were soldered by children in some sweat shop, so I'm not surprised if it doesn't work. Just want to make sure my logic is correct before I run out and by a FrSky replacement.
User avatar
entomophile
 
Posts: 12
Joined: Thu Dec 22, 2011 1:44 pm
Location: NJ

Re: Antenna wire question

Postby BillGriffiths100 » Sat Dec 24, 2011 10:20 am

Compromising with out of control government is like living with a lion, sooner or later the bloody thing will eat you .

You accept the tyranny of the state when it's not being applied to you, when it is: it's too late.
User avatar
BillGriffiths100
 
Posts: 553
Joined: Mon Sep 20, 2010 2:04 pm
Location: London UK


Return to Radios and Servos

Who is online

Users browsing this forum: No registered users and 2 guests

cron