Slider on 9X?

Problems, experiences or just something to say about RC gear? Say it here.

Slider on 9X?

Postby Olliemutt » Fri Mar 23, 2012 9:20 pm

Just curious as to whether or not it would be possible to replace one of the rotating knobs for a slider, like some of the new radios have. And mount it on the left side to use for flaps.
Don't care if I have to mount slider outside of the casing if room inside is an issue.
Olliemutt
 
Posts: 27
Joined: Thu Aug 26, 2010 9:12 am
Location: Southland New Zealand

Re: Slider on 9X?

Postby kaptain_zero » Sat Mar 24, 2012 1:09 am

Should not be a problem.... sliders are just pots after all. There are some that have put miniature joysticks on the back of the radio for pan/tilt of the onboard fpv camera.... I'd suggest switching to ER9X or other custom firmware on the 9X as it becomes much much more configurable. While I like this forum a lot, when it comes to ER9X in particular, I'd suggest checking out http://9xforums.com

Regards

Christian
"I'd like to live as a poor man with lots of money."
-- Pablo Picasso
User avatar
kaptain_zero
 
Posts: 197
Joined: Wed Mar 23, 2011 2:50 am
Location: Winnipeg, Canada

Re: Slider on 9X?

Postby RCModelReviews » Sat Mar 24, 2012 7:53 pm

Yes, if the 9X had sliders it would become the only radio I needed. When I need sliders I use my JR9XII (9303) or my Hitec Optic 6.
RCModelReviews.com, just the facts.
User avatar
RCModelReviews
 
Posts: 2120
Joined: Tue May 04, 2010 3:40 am

Re: Slider on 9X?

Postby Olliemutt » Sun Mar 25, 2012 1:33 am

Any suggestions where to buy suitable slider from?
Olliemutt
 
Posts: 27
Joined: Thu Aug 26, 2010 9:12 am
Location: Southland New Zealand


Return to Radios and Servos

Who is online

Users browsing this forum: No registered users and 3 guests