Page 1 of 1

Rssi from corona cr8d 2,4ghz receiver

PostPosted: Fri Jun 01, 2012 2:12 pm
by tomge
Hi guys,

Any of you managed to find were the rssi signal can be found on the 8 channel cr8d receiver from corona?
I'm getting into fpv, and for safety reasons would like to have the rssi signal displayed by my remzibi osd.
Haven't flown that far yet as i'm still learning to fly fpv, but would definetly like to have that info displayed when venturing into "the unknown"


Thx

Tom

Re: Rssi from corona cr8d 2,4ghz receiver

PostPosted: Fri Jun 01, 2012 3:02 pm
by BillGriffiths100
It's extremely complex, and requires you to intercept digital signals and decode them. There is no analogue rssi output from this receiver, someone has done it from a 72MHz corona RX perhaps that is why you think it can be done easily. http://fpv-community.com/forum/archive/ ... d-276.html
If you want RSSI get Frsky with telemetry that by far the best route you will spend forever trying to get the signal from the corona 2.4
Regards,
Bill

Re: Rssi from corona cr8d 2,4ghz receiver

PostPosted: Sat Jun 02, 2012 3:12 am
by pldb64
Bill,

Did you mean "FrSky"? .... Didn't think FlySky had telemetry!

Cheers
Peter (not a bot!!!)

Re: Rssi from corona cr8d 2,4ghz receiver

PostPosted: Sat Jun 02, 2012 8:50 am
by BillGriffiths100
pldb64 wrote:Bill,

Did you mean "FrSky"? .... Didn't think FlySky had telemetry!

Cheers
Peter (not a bot!!!)


Yes
Dooooh!

Re: Rssi from corona cr8d 2,4ghz receiver

PostPosted: Sat Jun 16, 2012 4:07 am
by tomge
Thx for the info guys
Will have a look at changing modules to frsky

Happy flying :)