Hi Roman,
Is this the unit you have:
- Tx4.JPG (26.6 KiB) Viewed 20396 times
- Tx2.JPG (31.12 KiB) Viewed 20396 times
If so then the DHT 2-way Tx module and Rx will be plug and play, keep the old module and Rx just in case. Bruces' vids revolve around the Turnigy, iMax, Eurgle 9x which has the Tx module hardwired to the transmitter and some soldering work is required if one is wanting to upgrade the radios Tx/Rx hardware (hardwired is Bruce's preference due to a previous misadventure).
Did you get a manual with the unit, if not PM me and I will email a PDF copy, once you have upgraded firmware you wont need it though.
You will get the most out of your unit if you upgrade the firmware to er9x (others are available but you need to upgrade the control unit to start with).
I took the easy way out because I am not that proficient with a soldering iron, have a look here:
http://www.smartieparts.com/shop/index. ... cts_id=331I see the price has gone down
, read through the site they explain most things here, pay particular attention to identifying your model of 9x it is important.
There is also a link to the 9xForums where mountains of information,hints,tips,clues and ideas abound. Once you have installed both units (was about 1/2 hour for me, I am pedantic) and installed er9x or other firmware a bigger world is opened for your 9x. You can install a Li-Ion battery pack and adjust the low voltage alarm (
http://www.rcmodelreviews.com/tendollarbattery.shtml), write or rewrite functions for your 9x on your computer then flash this to the 9x, download function programs already tested by other users (eepe files in my case).
The mixes and functions of your now "new" 9x will be "limitless", more models can be installed, the ability to mix elevons, flaperons etc etc. I only have 3 models AXN, 4 channel with gyro on airlerons (selectable headhold or rate modes), a delta wing 3 channel with elevons and a 450 heli 6 channel. I have one ghost model (really No 4) to operate my Phoenix Flight Sim program.
All up my 9x has cost, with mods, AUD$144, my Li-Ion batteries were acquired FOC
. My next stage is to upgrade the Tx/Rx modules to FrSky and I am working on programming flaperons for my AXN, not sure how that will function, nothing ventured nothing gained
.
Dennis