Reverse Engineer a Transmitter

Problems, experiences or just something to say about RC gear? Say it here.

Reverse Engineer a Transmitter

Postby iflylilplanes » Fri Aug 30, 2013 3:42 am

Is it possible to fit a modern 2.4Gig transmitter (say the new Taranis) with an 36 mhz FM module (Australian)?
Many Thanks,

Dave W.


Dead Stick Glide Distance: Half the distance from the airplane to the nearest emergency landing field.
User avatar
iflylilplanes
 
Posts: 91
Joined: Thu May 24, 2012 11:14 am
Location: Sydney, Australia

Re: Reverse Engineer a Transmitter

Postby BillGriffiths100 » Fri Aug 30, 2013 7:55 am

Yes no reason why old JR Form Factor RF Modules won't work but you will have to install a 35/36/37 Meg or whatever aerial and wire it to the correct pin on the module connector as this is left unconnected or earthed in the Turnigy.
The Taranis and the new 9xr haven't got a place for the 35/35/37 aerial but the Turnigy and variants do have the vestigial mountings used for the 35/36/37 aerials.
So the Taranis and the 9xr aren't good candidates and the Turnigy is your best bet.
Reverse compatibility only goes so far with the new stuff, try buying new 36 Meg gear, it doesn't exist!
Compromising with out of control government is like living with a lion, sooner or later the bloody thing will eat you .

You accept the tyranny of the state when it's not being applied to you, when it is: it's too late.
User avatar
BillGriffiths100
 
Posts: 553
Joined: Mon Sep 20, 2010 2:04 pm
Location: London UK


Return to Radios and Servos

Who is online

Users browsing this forum: No registered users and 2 guests

cron