Page 1 of 1

TX firmware

PostPosted: Wed Oct 16, 2013 12:03 pm
by Barnstormer
Hi guys anybody know if its possible to upload the Taranis firmware onto a Kingmax/KST T810 Tx?.... :!:

Re: TX firmware

PostPosted: Wed Oct 16, 2013 2:46 pm
by BillGriffiths100
Unless it's an exact clone of Taranis, including all connections and processor no.

Re: TX firmware

PostPosted: Thu Oct 17, 2013 11:03 am
by Barnstormer
Thanks Bill....not 100% but the Taranis may be a clone of the Kingmax/KST radio as the Kingmax was available before Taranis appeared

Re: TX firmware

PostPosted: Fri Oct 18, 2013 1:30 am
by cynr100
Kingmax has been around for some time, it and the Taranis share the same or very similar external shell as the Futaba from years past. Some POTs and switches differ in position, it would require a deep pocket to trial without knowing the internal differences.
Not sure you could even install Er9X firmware to the Kingmax. You might want to have a search through here.......
http://openrcforums.com/forum/viewforum.php?f=5

Re: TX firmware

PostPosted: Fri Oct 18, 2013 7:59 am
by BillGriffiths100
The Taranis is based on the 9x layout but the processor is an ARM processor not the Atmel used in the 9x so it's very unlikely that the firmware would be compatible. The resemblance is only skin deep.