Hi I have a electric plane ( Eflight Ultra stick 25e) that I am running with a 60amp turnigy plush speedy with a inbuilt switching BEC. I had a problem today where it had appered to loss power to the Rx for a short time, causing the plane to crash, (I think it was a bad connection from the plug into the Rx) being a spektrum Rx the short power outage meant it rebooted when power came back but the rebind was to slow and being only 10m of the ground the isn't much time for the reboot to happen. I am guessing it was a power outage as the Rx was flashing when I went and picked up the bits, and all servos where moveing normaly. I know that if this happened to my Frsky, the reboot would of been instant and would of showed up as a glitch. But anyway I ahve a Ubec which people say you should install in larger Speedies. If i run the speedy and a separate Ubec off the same battery and plug them both into the Rx do I have to disconnect one of the + or - lines off either one so its not getting power from both "becs" to the Rx or because they would be effectedly suppling the same voltage or close to the same to Rx would it be ok. I was thinking this would be like a fail safe, that if one bec failed the Rx is still getting power from the other Bec.
Hope someone can help with this.
Regards David