RC Model Reviews

Hello to all,
i hope that someone will help.
I have to set gear sw with one retract servo.

I go to AUX-CH ,set CH5 to GEAR. When i flip sw nothing hapends.
Servo is pluged in CH5,and if i set CH5 to pit-trim or hov-thr and move pit-trim or hov-thr servo is working.

Thanks to all.

I set it up ,it works now ,just have to create new model.
Is it possibile to slow retract servo ,some curve adjustment ?


regards , Marko

No, although some radios like the JR9X have the ability to slow a servo -- even this only works if you're using a regular servo on your retracts because proper retract servos only have two positions - they're not proportional and their speed can't be controlled by the transmitter.

I will use rectract servo - BMS-136MG Retract Servo .


Can i set endpoints on radio for retract servo ?
Can i use http://www.hobbyking.com/hobbyking/stor ... oduct=8863 (Turnigy 3 Channel Servo Speed/Direction Regulator) ?

You can set endpoints for a regular (proportional) servo but if you're using a special retract servo they only have two positions that can't be changed by the radio and the speed also can't be changed.

What servos are you using?

I will use BlueBird BMS-136MG Retract Servo- http://www.hobbyking.com/hobbyking/stor ... oduct=8770 .
If i can't do it on radio ,how to set end position when gear door is closed and position when it's opened?
You think that i can use http://www.hobbyking.com/hobbyking/stor ... oduct=8863 (Turnigy 3 Channel Servo Speed/Direction Regulator), to slow servo speed?
I will use retracts on CMP Zero 50.

thanks

This is a dedicated retract servo so it will only turn to two positions and you can't change the speed at which it rotates.

Because of that, nothing you do with the transmitter will slow it down, nor will the servo-speed regulator have any effect.

Thanks Bruce !