FrSky Set up

Problems, experiences or just something to say about RC gear? Say it here.

FrSky Set up

Postby jet760 » Wed Aug 25, 2010 2:22 pm

Hi Bruce I was setting up my new Frsky 7 channel Rx in my Eflight Ultra stick and was thinking about the antena placements. they say to run 1 antena at 90 degrees to the other I have included some photos do you think this ok ? I have 1 antena coming out the side of the fuz at 90 degrees to the fuz and the other coming the bottom of the fuz running along down the fuzdo you think this set up is ok. With the antena coming out the side of the fuz I am thinking to place some antena tube over it to keep it from folding back when flying. you help on this would be much appreciated. It is my understanding it is best to have these antenias out side the fuz or can you leave them inside.
regards David
Attachments
25082010602.jpg
antena coming out bottom
25082010602.jpg (65.92 KiB) Viewed 1003 times
25082010601.jpg
antena coming out side
25082010601.jpg (92.57 KiB) Viewed 1003 times
jet760
 
Posts: 59
Joined: Mon May 31, 2010 12:36 pm

Re: FrSky Set up

Postby RCModelReviews » Wed Aug 25, 2010 10:36 pm

The only problem I can see is that the antenna which simply protrudes from the fuselage at 90 degrees will be blown back by the slipstream as the model moves through the air. I'd be more tempted to run vertically against the fuselage side -- you can do this inside the model since the balsa won't affect the signal in any real way.
RCModelReviews.com, just the facts.
User avatar
RCModelReviews
 
Posts: 2120
Joined: Tue May 04, 2010 3:40 am


Return to Radios and Servos

Who is online

Users browsing this forum: No registered users and 3 guests

cron