RC Model Reviews

Hi guys.


Sorry to bug you again. After waiting for ages my stuff finally showed up last week. All accounted for and in good nick.

Decided to just get stuck in today but ran into a slight issue.

Turns out that we have two white, a gray and an obvious antenna which is black.
It appears that the gray is definitely the positive but I am getting 8.6 volt on 1 of the whites and 11 volt on the other.
Can I just confirm with somebody that the one I am getting 11 Volt on is -0V or Neg. and the 8.6 volt one is the data?

Cheers

Arjan

https://www.dropbox.com/s/y21q1f20f6w9jyy/2013-11-10%2013.47.37.jpg

Try this attachment that shows pin assignments.

Forget that, Board won't allow attachments. You've identified the antenna feed, right? So working from that side of the four pin plug, the connections are in turn Antenna - Gnd - Signal - Power.

Hope that helps.