Has anyone tested at what voltage this little receiver will brown-out?
Specs say operationl voltage is 4.0 to 7.2 Volt, but I can't imagine it will shut down at 3.9V...
I'm setting up a 1S system for a mini-DLG with 3x 1S-nanoservo's and a 1S 160mAh. Voltage is likely to drop to 3.5V under load... the 8 channel version can go as low as 2.7V isn't it?
Cheers,
H.
Low-voltage on FrSky V8R4
3 posts
• Page 1 of 1
Low-voltage on FrSky V8R4
by hummel » Mon Sep 13, 2010 9:14 pm
- hummel
- Posts: 20
- Joined: Tue Sep 07, 2010 9:04 pm
Re: Low-voltage on FrSky V8R4
by RCModelReviews » Tue Sep 14, 2010 1:49 am
When I reviewed the 8-channel, they worked just fine down to about 2.8V
I would expect the 4-channel would be about the same. I run my DLG on a 4-cell NiMH pack that gets pretty low at times and I've never had an issue.
I would expect the 4-channel would be about the same. I run my DLG on a 4-cell NiMH pack that gets pretty low at times and I've never had an issue.
RCModelReviews.com, just the facts.
-
RCModelReviews - Posts: 2120
- Joined: Tue May 04, 2010 3:40 am
Re: Low-voltage on FrSky V8R4
by hummel » Mon Sep 20, 2010 2:17 pm
The FrSky website is updated: it now states an operational range of 3.2 to 7.2 V.
So a single Lipocel should be sufficient, even under load.
Cool stuff!
So a single Lipocel should be sufficient, even under load.
Cool stuff!
- hummel
- Posts: 20
- Joined: Tue Sep 07, 2010 9:04 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 21 guests