Page 1 of 1

Ferrite rings & 2.4ghz JR DMSS!

PostPosted: Mon Nov 19, 2012 7:39 pm
by ChrisTTsport40
Hi!
Does anyone know if the ferrite ring to servo cable near to RX RG831B create problem to the range?

Re: Ferrite rings & 2.4ghz JR DMSS!

PostPosted: Wed Nov 21, 2012 1:31 am
by zann68
Would not think so. Ferrites are used to clean noise out of electronics. Don't see how it would effect the RX signal.

Re: Ferrite rings & 2.4ghz JR DMSS!

PostPosted: Wed Nov 21, 2012 5:44 am
by ergocentric
zann68 wrote:Would not think so. Ferrites are used to clean noise out of electronics. Don't see how it would effect the RX signal.


Noise just like servo PWM signals, your servo may suffer, Optoisolator is the way to go.

Re: Ferrite rings & 2.4ghz JR DMSS!

PostPosted: Wed Nov 21, 2012 12:37 pm
by ChrisTTsport40
I put the ferrite ring in the servo extension rear of the RX!
I ask because the MAnufacture say no metal or carbon near of the receiver!
And the ferrite ring is made of metal and charcoal i think!