Hello
I have a later 9X and the board seems slightly different where you solder the resistor, There is a contact pad in the top track and I could solder in a surface mount resistor as in my photo.
Polanskiman wrote:Hello boys and girls,
I am on the verge of purchasing the Turnigy 9x V2. I want to install the FrSky DHT Tx module. I have seen the DIY $8 Lithium Transmitter Battery mod. done by Bruce (http://www.rcmodelreviews.com/tendollarbattery.shtml). Questions:
1. Is this possible with the Turnigy 9x Version 2?
2 If so, is the resistor installation still necessary in this Versions?
Thanks for the inputs.
P
FlyingTiger wrote:Polanskiman wrote:Hello boys and girls,
I am on the verge of purchasing the Turnigy 9x V2. I want to install the FrSky DHT Tx module. I have seen the DIY $8 Lithium Transmitter Battery mod. done by Bruce (http://www.rcmodelreviews.com/tendollarbattery.shtml). Questions:
1. Is this possible with the Turnigy 9x Version 2?
2 If so, is the resistor installation still necessary in this Versions?
Thanks for the inputs.
P
To answer your questions, yes it is possible to do the $10 battery mod on the T9x V2. The resistor is required to stop the low battery warning from sounding continuously. But, if you upgrade the radio to ER9x software, you can set the low battery warning to whatever voltage you like and you won't have to solder in any resistors. If you put in the resistor ant then later go to ER9x software, you will need to remove the resistor.
Polanskiman wrote:Hello boys and girls,
Which brings the question: What does the ER9X software update bring to the Tx (apart from setting the battery warning level). Sorry if this has been asked before.
quarry44 wrote:This mob appear to have stock:
http://www.omgfly.com/index.php?main_pa ... cts_id=468
YMMV.
Return to Receiver/transmitter Batteries
Users browsing this forum: No registered users and 13 guests