Page 1 of 1

OrangeRx 6ch

PostPosted: Sat Nov 06, 2010 3:04 pm
by Knorm
Hello Everyone;
This may be an old topic but I need some help.
I just recieved 3 OrangeRx 6 channel RX from Hobby King and I can't get any of them to bind to my DX6i. When I plug in the Li-po the Rx light comes on steady and will not bind. I have the Bind plug in the Batt/Bind port and the ESC wire in the THRO port and I plug in the power to the Rx prior to turning on the DX6i with the Train switch held on. I also have an AR6110e for this plane and it binds and functions fine even after I tried all 3 Orange Rx's.
Can I plug the ESC wire into the BATT port and put the bind plug in the AUX1 port without damaging anything and will that work?
Anyone have any advice?

Re: OrangeRx 6ch

PostPosted: Sat Nov 06, 2010 4:41 pm
by Knorm

Well I think I solve my issue. I found a thread that said the S on the side of the OramgeRx is for the Signal and is upside down from the AR6110e. So I pluged in everything with the white signal wire (S) matching the S on the Rx and it works. I was able to bind to my DX6i and everything funtions. Thanks for reading my posts, I hope this will help someone else.


Re: OrangeRx 6ch

PostPosted: Thu Nov 11, 2010 12:07 pm
by K9000wner
watching this orange rx

Re: OrangeRx 6ch

PostPosted: Thu Nov 11, 2010 9:39 pm
by RCModelReviews
I just received a couple of these receivers (HK never did send the promised review sample so I bought them from the review budget).

I'll be publishing my findings in due course.