ER9X mixing help required
Posted: Sun Sep 11, 2011 2:53 am
I just completed the mod to get 180 degrees out a hextronik HXT900 servo (the little blue 9g). Very simple but you need a steady hand to solder the two 2.2k resistors in the tiny space. Wish I had surface mount resistors. But it works
http://www.youtube.com/watch?v=Hst0hrpPCtg
This 180 degree servo (channel 6) is driving the pan of the camera, original these servos are only 90 degrees or so. With this mod I can point the tilt servo (channel 8) much lower to look steep down over the side of the fuselage. Problem is that I need to bring it up to pan to the other side of the plane otherwise I will hit the canopy.
I am well and truly lost how to set-up this in the ER9X so that in a certain mid-section of the pan (C6) the tilt (C8) does not go below a certain angle.
Any takers? Many thanks.
http://www.youtube.com/watch?v=Hst0hrpPCtg
This 180 degree servo (channel 6) is driving the pan of the camera, original these servos are only 90 degrees or so. With this mod I can point the tilt servo (channel 8) much lower to look steep down over the side of the fuselage. Problem is that I need to bring it up to pan to the other side of the plane otherwise I will hit the canopy.
I am well and truly lost how to set-up this in the ER9X so that in a certain mid-section of the pan (C6) the tilt (C8) does not go below a certain angle.
Any takers? Many thanks.