Page 9 of 10

Re: Bruce' FPV Diversity Controller project

PostPosted: Thu Feb 21, 2013 6:28 pm
by RONALD MCDONALD
chossy wrote:i have ordered the parts to go down Rixx's route but Ronald's 4 RX picaxe route also looks good.
Now can i merge the 2 projects and do away with the relay/arduino as i had planned to make the RX/Power/Relay/switcher boards all modular (is that the correct term) so if something breaks i just swap it out.
Ronald would you mind answer a few questions i have ?

Here is the video distribution amp you asked for.

Re: Bruce' FPV Diversity Controller project

PostPosted: Fri Feb 22, 2013 1:18 pm
by chossy
RONALD MCDONALD wrote:
chossy wrote:i have ordered the parts to go down Rixx's route but Ronald's 4 RX picaxe route also looks good.
Now can i merge the 2 projects and do away with the relay/arduino as i had planned to make the RX/Power/Relay/switcher boards all modular (is that the correct term) so if something breaks i just swap it out.
Ronald would you mind answer a few questions i have ?

Here is the video distribution amp you asked for.


Thanks Ronald .
5w audio amp working now just this and program the oled and should be done.

Re: Bruce' FPV Diversity Controller project

PostPosted: Sat Mar 02, 2013 5:35 pm
by hammer833
Bruce how are things coming on this project? I can't wait to build one of these! Your super simple instructions makes all this "electronic voodoo" stuff easy to follow. I have no electronics experience and can't read that schematic mambo jumbo, but I can solder. I have built 3 over your FPV backpacks that work flawlessly using your instructions. But I need a Diverse city controller and I'm not paying $100 plus for one of the commercially available ones that only two inputs and not four like yours. And its only $25!!

Any way, was just wondering where things were at.

Thanks Rick

Re: Bruce' FPV Diversity Controller project

PostPosted: Thu Mar 14, 2013 9:39 am
by denis1
Hi Bruce, just wondering how you are getting along with your design of your 4 way diversity unit. Keen to make one. Thanks.

Re: Bruce' FPV Diversity Controller project

PostPosted: Thu Mar 14, 2013 9:44 am
by denis1
Looks good bruce, would you mind doing a video and parts for this project, Thanks again.

Re: Bruce' FPV Diversity Controller project

PostPosted: Wed Apr 24, 2013 8:36 am
by Buzzard
Hi Bruce, I know you are busy and a little stressed at the moment. However I am looking for a reliable Diversity controller.. Are you selling this as a completed system or a kit?

Re: Bruce' FPV Diversity Controller project

PostPosted: Wed Oct 09, 2013 8:07 am
by mtesa
Maybe I'm blind a bit and slow a bit more, but I could not find finished diversity switch in this thread ... ?!?
Is this project completed?

Re: Bruce' FPV Diversity Controller project

PostPosted: Wed Oct 09, 2013 11:28 am
by sindre
Nope, not finished

Re: Bruce' FPV Diversity Controller project

PostPosted: Wed Oct 09, 2013 5:11 pm
by mtesa
bummer

Re: Bruce' FPV Diversity Controller project

PostPosted: Sat Oct 12, 2013 5:12 pm
by bob332
bump to get this done :D