by pldb64 » Thu May 17, 2012 1:18 am
If you've done this conversion recently, then presumably you'll have either the DHT or DJT Tx module (the DIY or internal module is the DHT, DJT simply slots into the back of the 9x - nothing internal). In either case, these are two way Tx modules which can be set to work with either 1way Rx modules or 2way Rx modules. In the case of the DHT module, there is a three way switch which selects which mode the Tx module will operate in. In the case of the DJT module, the dip switches at the back allow for this mode setting.
Hence you can set the Tx module such that it will work quite happily with a 1 way Rx. So if you've got V8 Rxs - these should work quite happily if you've set the Tx to 1 way mode.
D series Rxs are required for 2way telemetry.
Turnigy 9x, FrSky 2-Way/Telemetry DHT DIY, Smartieparts BRD, ER9x FW
AXN-Floater (stock esc, motor & prop, HK orange 9g servos)