Position-correcting router

If you've been building electronic bits or modifying stuff you've bought then tell us all about it here. A good place to discuss the installation of 2.4GHz DIY modules too.

Position-correcting router

Postby mikem » Sun Sep 23, 2012 3:06 pm

Here's a nifty bit of technology for free-hand cutting 2D parts from sheet stock... if you guide a modified power tool, such as a router, within a quarter-inch of the desired cut line, an on-board controller jogs the tool mount to improve the precision of cut:

http://groups.csail.mit.edu/graphics/po ... tingtools/

YT video at:

http://www.youtube.com/watch?feature=pl ... UmL7xZZSUk

Might be an interesting hack using Arduino or Raspberry-Pi, a couple of steppers or tough servos, and line-follower optics/software.

I can see such a system following a printed pattern attached to the stock, but it would be way cooler just to project pattern segments onto the stock from on-board memory somehow, i.e., to give the operator a light-line to follow.

Here's the original NYT article:

http://www.nytimes.com/2012/09/23/techn ... emityn.www
mikem
 
Posts: 24
Joined: Sat Aug 04, 2012 9:46 pm
Location: Bangor Maine US

Return to DIY Projects and Hacks

Who is online

Users browsing this forum: No registered users and 3 guests

cron