RC Model Reviews

I have a E-fly radio that has a simulator port that I think outputs the PPM signal through the mono headphone jack. I measured the voltage with a multimeter and the center is positive 3.7V. I think this is the PPM signal because it comes with a USB dongle for FMS and says PPM in the control panel. And it works fine with FMS too. Could I use this as the contact point to solder the PPM signal wire from the FrSky module?

I'm no expert here mind you, but that seems a bit high compared with my experience with a JR 2610 PPM signal. It measured with a voltmeter ane 'average' voltage of 0.5v for PPM signal. This signal is not a static one so there is no accuracy in this figure.

You may need the diode mod for this one if voltage is high, I believe the target voltage is 3.3v, read all you can on this site re PPM voltage to find more.

Only way to know for sure is to measure with an oscilloscope unless someone else has tested this Tx before?



viewtopic.php?f=47&t=342

I got it working. The ppm signal was in the sim port At 3.7v. my frisky module had a diode on it already so all is good. I was able to bind it to a V8R4 rx.

hi I want to know if it will be posable to take the frsky JR or futaba module and bild it into a non module baced radio. as I order a diy module of frsky from hobbyking and thy still hade stoke the day I submited m order and now thay tell me there was a error on the system so thay have stok of the jr moduls so I were thinking of taking it out of the box and build it into my JR2610 TX