Page 2 of 2

Re: Futaba Conquest radio conversion to 2.4(Help Wanted)

PostPosted: Sun Jun 06, 2010 1:50 am
by ergocentric
rotorcrafts wrote:Also what effect will the trainer switch have on the 2.4 system if it is activated when the 2.4 system is working.


Unless you know precisely what you are doing I would not recommend rewiring then using it as an instructor transmitter.

Re: Futaba Conquest radio conversion to 2.4(Help Wanted)

PostPosted: Sat Jun 26, 2010 6:25 am
by Tarasdad
Will this module work on a Conquest 6-ch AM transmitter (Futaba mod. # FP-T6NLK)?

Re: Futaba Conquest radio conversion to 2.4(Help Wanted)

PostPosted: Sat Jun 26, 2010 1:24 pm
by rotorcrafts
ergocentric wrote:
rotorcrafts wrote:Also what effect will the trainer switch have on the 2.4 system if it is activated when the 2.4 system is working.


Unless you know precisely what you are doing I would not recommend rewiring then using it as an instructor transmitter.



Thankyou for your help. well i already converted my radio using the trainer port, I removed the trainer port plug from the main board and i identified the -ve and +ve wire. One of the remaininng two wires was of the PPM signal so taht wasnt difficult at all. I also found a four pin connector that nicely seated on the four protruding pins. I dont have a trainer port now but i am on 2.4ghz :D

Re: Futaba Conquest radio conversion to 2.4(Help Wanted)

PostPosted: Sat Jun 26, 2010 1:25 pm
by rotorcrafts
Tarasdad wrote:Will this module work on a Conquest 6-ch AM transmitter (Futaba mod. # FP-T6NLK)?



I think it should.