Page 1 of 1

PROPER 2.4GHZ RECEIVER INSTALLATION

PostPosted: Fri Jan 18, 2013 4:33 am
by AshleyB32
with alot of people going from there old systems to the newer 2.4ghz systems these days would be good to know the proper install for the 2.4ghz receivers, just an idea

Re: PROPER 2.4GHZ RECEIVER INSTALLATION

PostPosted: Fri Jan 18, 2013 8:51 pm
by quarry44
With most 2-wire aerials,they should be at 90 degrees to each other.Single wire no problems.Put it where it's convenient.
I mount my receivers on velcro patches attached to the fuse bottom(inside,of course) or side.
Common sense suggests to keep rx away from esc if possible,but in my AXN,the rx (Frsky)is virtually on top of the esc,and has not given any problems.