Page 2 of 2

Re: Turnigy 9x DIY evolutionary path - comments?

PostPosted: Mon Nov 07, 2011 2:47 am
by pldb64
rogueqd wrote:You do not need step 3 if you are going to do step 4.


Duly noted - Telemetry DIY is now enroute (slow boat etc) ... so step 3 now deleted from the plan

rogueqd wrote:I would rate the Smartieparts board as C-2, being easier than the resistor mod, and the er9x software as A-novice B-8 with the original 9x software being A-almost useless B-2. The er9x software is more complex but also more intuitive than the original software, so I'd recommend upgrading as soon as you want to program more than one switch, saving yourself the headache of learning the original which can only ever program two switches anyway.


Looks like there is a lengthy delay on these boards at the moment and demand is growing daily :-) ... a good problem for the supplier i guess. :-)

Thanks everyone for your comments & thoughts.