Page 1 of 1

Re: Adding an EBEC to a system wich has a ESC with bec.

PostPosted: Wed Apr 25, 2012 6:45 pm
by Shotglass
yes that is the way to do it
signals are usually always ground referenced so youll want to cut the positive wire

btw in case you may want to use the esc for something else later using a servo extension wire and cutting that instead of the wire of the esc itself will save you some headaches down the road

Re: Adding an EBEC to a system wich has a ESC with bec.

PostPosted: Wed Apr 25, 2012 8:25 pm
by Flash1940
Or.....if you're meticulous....you could remove the red wire from the connector by pushing down on the locking tab with a sharp pointed object while pulling gently on the red wire. Fold it back & tape it up for another day....
Flash

Re: Adding an EBEC to a system wich has a ESC with bec.

PostPosted: Wed Apr 25, 2012 8:43 pm
by quarry44
Just like this:
Image