AXN magnets

Here's an area where you can ask any kind of question about RC models and find a whole lot of useful information to help you get started.

Re: AXN magnets

Postby quarry44 » Sat Feb 16, 2013 9:12 pm

The accelerater just makes the superglue go off faster.You don't have to use it if you don't want to.
Tap the retaining clip flat before re-fitting.And of course,epoxy is perfectly fine too,if you happen to have some at hand.
Posts: 383
Joined: Fri Aug 19, 2011 6:58 am

Re: AXN magnets

Postby wesselspeed » Sat Feb 16, 2013 11:17 pm

Hah i found some epoxy in a drawer and it was still usable, but maybe i used a bit to much.
Would a little bit too much glue harm the motor balance?
And how can i identify and correct an unbalanced motor (if neccesary)
Robotronic Stinger est. BL + 3, 3000 MaH lipo's + Team Orion Advantage Lipo Edition :)
AXN ARF, Orange servo's, 30A blue ESC, 2200 mAh 20c zippy, Turnigy 9x, HK 6ch reciever
808 #3 camera
Posts: 27
Joined: Tue Jun 19, 2012 9:53 pm
Location: Stiens, Netherlands

Re: AXN magnets

Postby quarry44 » Sun Feb 17, 2013 11:08 pm

but maybe i used a bit to much
How much is a bit?The glue should be no thicker than the magnets,or you will have a similar problem to what you had in the first place.
If you're worried about balance,put the same amount of epoxy between the magnets on the opposite side of the bell.
Posts: 383
Joined: Fri Aug 19, 2011 6:58 am


Return to For Beginners (if you're just getting started in RC)

Who is online

Users browsing this forum: No registered users and 4 guests