RC Model Reviews

Hi guys just wanted to start a new topic, i have the 9x vers 2 and need to find out how to setup flaps using the 3 position switch on a Multiplex funcub, have searched you tube but cant find one that is specific to just setting up flaps using the 3 position switch, if any has instructions on how to do this would be much appreciated.

Hi Aussiepaul,

This may be of assistance, if you are using the stock 9x firmware.
http://9xforums.com/forum/viewtopic.php?f=37&t=1004
First, you must have one servo for each aileron and one channel for each servo, a 4ch Rx is not enough. I have not use the stock firmware for this, the er9x is much easier, how ever these condistions would still apply.

Not quite sure how to use this form yet but I have a turnigy 9X put a life battery in it 9.9 V 1800 wondering at what voltage should I recharge it and does this radio have a low-voltage alarm that will go off when it's too low so I don't crash my planes does anybody know anything about these radios

The low voltage alarm goes off at 9 volts on the standard software.

Lithium iron phosphate (LiFePO4) battery:
Min. discharge voltage = 2.8 V
Working voltage = 3.0 ~ 3.3 V
Max. charge voltage = 3.6 V
So charge at 9 volts or thereabouts

Thanks for answering the last post you wouldn't happen to know what I charge 9.9 volt 1800 life battery at is it just like a Lipo 1.8?

No it requires a lower cut off voltage see Bruces video about the turnigy charger he explains all:
see his video channels
http://www.youtube.com/watch?v=eX_Tuv6WOf8