Page 1 of 1

F/S button location on TFR8 2.4 GHz Rcvr

PostPosted: Mon Nov 01, 2010 4:07 pm
by jsham5
I finally received the TFR8 2.4GHz, FASST compatible, FRSKY receiver yesterday. I see the LED lights on top of the unit but am not sure where the F/S button is located for Binding to my Futaba 6EX 2.4GHz transmitter.

Also, is the top pin in each channel connected to the + or - lead, assuming the middle pin is for signal? In Futaba it would be negative.

Jsham5

Re: F/S button location on TFR8 2.4 GHz Rcvr

PostPosted: Tue Nov 02, 2010 7:35 am
by RCModelReviews
The row of pins which are closest to the edge of the board is the negative.

The FS button is the only button on the receiver -- it's the same one used for binding.

Here's how to change, according to the instructions:

Turn the transmitter off, connect the battery to the receiver, press the F/S button on the receiver for 6 seconds and release. The red LED will flash quickly in HS mode and slowly in FS mode