bmsweb wrote:Segways and Model Aircraft in the same warehouse don't mix
rogueqd wrote:I glued the spar covers on to the wings, but made sure I left the gap for the servo leads unglued in case they ever need replacing. I also made sure the spar slid in and out smoothly before I let the glue dry. I've noticed the glue works better if you lightly sand the surfaces, I used 400 grit.
RCModelReviews wrote:I didn't use bullets on the ESC to motor connection -- I just soldered the wires together -- but don't shrink the heatshrink until you've tested it
ergocentric wrote:Those are not bullet connectors per se, the are XT60 connectors, I ordered some just *after* my new batteries arrived, sigh. I removed them and soldered on JST for that particular aircraft (Storm Launcher)
Return to Where to buy (and not to buy)
Users browsing this forum: No registered users and 2 guests