...awaiting your report with bated breath...
Thank you in adavance for your efforts.
Ordered my V2 last week, since 4 days on its way, but still no tracking *sigh* and still 3 Rx in Backorder.
RCModelReviews wrote:I've just finished my initial testing of the Turnigy 9X V2 and I can advise that it is now a FHSS system that uses the entire band (in 16 evenly spaced channels).
There are good and bad things to report -- the full review (on the web and in video) should be up tomorrow.
brunors wrote:1 - How to install the receiver antenna? Can I install it inside the fuselage?
2 - Is it possible to use PCM in this turnigy 2.4 system? When I have selected that modulation, is does not works!
Andrej wrote:
You can try the newest version of this project code.google.com/p/th9x
Before you flash you have to do a backup of the original binary, so if anything goes wrong you can flash the original back.
Here are the instructions.
I have not tried anything yet, but i will when i receive my Eurgle V1.
huha wrote:Hi,
I received the "v2" without the 2.4ghz module and antenna too. Even thus I ordered the one with module and antenna.. might even be a v1 I wouldn't know.
It has bugs like saying "mode 1" when i have mode 2 selected, or beeping and not saving when I go into the main menu directly at startup.
I am wondering about the alternative firmwares, which one is "the best" (most complete/easy or just a subjective best) and how dangerous is it to use it? Can it "brick" the radio or it's always recoverable?
How do you really make the connector? Articles are not very accurate and it seems that you need to know what you're doing beforehand.. I can solder and stuff but i've no experience into hacking the radio and connectors (I found that at best but.. it doesnt tell what you connect on the PC side: http://sourceforge.net/apps/mediawiki/r ... nstall_ISP)
Thanks
Return to 2.4GHz radios/modules/receivers
Users browsing this forum: No registered users and 0 guests