eg
6in1 parallel charging board Imax Balance B6 B8 charger S available on ebay etc..
Are these effective? can it overload and do damage to a charger designed for one battery?
How can the charger balance cells that are connected in parallel?
opix wrote:And if want to use/charge for example two lipo batterys (2 x 11.1v 2200 mah) in 'chain' then the total exit vlotage/capacity would be 22.2v/2200 mah or 22.2v/4400 mah ?
S-rob wrote:If the batts have differing internal resistances, then they will both charge at differing rates.
ie. more charging current will go into the batt with lower resistance.
Not sure if this will be a real issue, unless the actual charge rate goes over the recommended for that lipo
In other areas, paralleling has some sort of current sharing/equalizing device built in, say a resistor.
Users browsing this forum: No registered users and 3 guests