connecting FPV camera to OSD

To discuss all things relating to flying models via remote video

connecting FPV camera to OSD

Postby francoishaha » Sun Apr 15, 2012 1:41 am

I need help to connect my fpv camera to the eagle tree OSD pro.

My video Tx is powered with a 2s lipo. My question is if i cut the camera wire in 2 part, the camera part goes to OSD video in and the Tx part go to the OSD video out, will this work?

here a picture:
http://i.imgur.com/rp6FA.jpg

i wonder if i got to put voltage regulator between the camera and the OSD?
because my camera is 5v
User avatar
francoishaha
 
Posts: 63
Joined: Sun Oct 02, 2011 4:02 pm
Location: Quebec Canada

Re: connecting FPV camera to OSD

Postby RCModelReviews » Thu Apr 19, 2012 3:22 am

I am not familiar with the EagleTree unit but I'll see if I can find out for you.
RCModelReviews.com, just the facts.
User avatar
RCModelReviews
 
Posts: 2120
Joined: Tue May 04, 2010 3:40 am

Re: connecting FPV camera to OSD

Postby francoishaha » Thu Apr 19, 2012 11:56 pm

I just find out how to do it, but thanks Bruce.

The osd video and audio in are independent for powering so whatever the camera voltage, the power just loop back.
here what i find in the instruction manual: (the subject was about the video in and out of the osd)
"the Power pins are connected together internally in the OSD PRO, for your convenience"
User avatar
francoishaha
 
Posts: 63
Joined: Sun Oct 02, 2011 4:02 pm
Location: Quebec Canada


Return to FPV

Who is online

Users browsing this forum: No registered users and 1 guest