Here's an area where you can ask any kind of question about RC models and find a whole lot of useful information to help you get started.
yes that is the way to do it
signals are usually always ground referenced so youll want to cut the positive wire
btw in case you may want to use the esc for something else later using a servo extension wire and cutting that instead of the wire of the esc itself will save you some headaches down the road
- Posts: 106
- Joined: Mon Jun 27, 2011 5:52 pm
Or.....if you're meticulous....you could remove the red wire from the connector by pushing down on the locking tab with a sharp pointed object while pulling gently on the red wire. Fold it back & tape it up for another day....
- Posts: 94
- Joined: Sat Sep 04, 2010 2:48 pm
- Location: Paris, Kentucky.....Central Kentucky USA
Just like this:
- Posts: 369
- Joined: Fri Aug 19, 2011 6:58 am
Return to For Beginners (if you're just getting started in RC)
Who is online
Users browsing this forum: No registered users and 0 guests