Hi, I've a problem with Trainer (Master-Slave) function.
My T9x (used as Master) seems to do not accept input from my HK T6a (it is a 6ch, modified to be used for Training in both Master and Slave mode and used as Slave).
My T6a (used as Master) succesfully accept input from the T9x (used as Slave).
I've verified, from T6a the PPM signal is correctly generated.
Both radio are configured in Mode 3, both are V2 version and T9x has the original firmware.
When in Master mode (i.e. it wait for external PPM signal), on the DSC plug on T9x there is a fixed +5V signal. Is it normal?
What should be appened? Is it possible that T9x do not accept a PPM with less than 8 channel?
Anyone has used this radio as Trainer (not for simulation on PC but for fly teaching...)? What is the correct sequence to setup it as Master? The manual is really poor on this.
Thanks
Cico