ergocentric wrote:rotorcrafts wrote:Also what effect will the trainer switch have on the 2.4 system if it is activated when the 2.4 system is working.
Unless you know precisely what you are doing I would not recommend rewiring then using it as an instructor transmitter.
Thankyou for your help. well i already converted my radio using the trainer port, I removed the trainer port plug from the main board and i identified the -ve and +ve wire. One of the remaininng two wires was of the PPM signal so taht wasnt difficult at all. I also found a four pin connector that nicely seated on the four protruding pins. I dont have a trainer port now but i am on 2.4ghz