I took my AXN for its maiden flight yesterday. It flew fantastically. As a newbie, I found it easy to fly.
However, on my last flight I was caught short. The ESC cut the motor because of low voltage. I was taking off and it caught me by surprise. I lost control and it fell out of the sky. The only damage was the motor falling off. The glue let go. I found that the motor was only glued in one place – the vertical face of the foam motor pod. It was not glued in the top of the pod where the plastic motor holder has a fin which goes into a slot on top of the motor pod.
So my questions is, should it be glued both on the top and the vertical face? If I glue it on the top of the pod, will I be able to replace the motor if it dies – without badly damaging the foam motor pod?
Thanks,
André