Where to glue the AXN engine mounting?

[BillGriffiths100]

If you have a severe ding in the leading edge,you can always cut a square piece out around the ding.Then get a piece of spare foam(packing),cut a bit bigger than the piece you previously cut out,and glue in with gorilla glue or WHY,and let dry overnight.Next day,using very fine sandpaper(180 or higher),sand the repaired section back to wing shape.It'll be barely visible.

Hey, just what I was going to say, but to add to that you can use the clear parcel tape to wrap around the profile afterwards to seal the surface.

[cynr100]

This is a good demonstration of just how much an AXN can bear:

http://www.youtube.com/watch?v=nsWaELPUpgk&feature=plcp

Thanks to Bruce and the dudes at SWMAC, is it still flying

[Andre]

Thanks - I'll remember that for the future - this one is not big enough to warrant it. When I get a big ding, I'll do all the dings...