Hi everyone I have read a lot on this site however this is my first post.
I just bought a turnigy 9x transmitter, ANX plane, frsky dht-u, batteries to do the $8 battery mod, couple receivers.
My problem is I get a volt Reading of 1.1 and the low voltage warning peeping .
I checked the voltage at the battery holder wire plug and get 11.4 volts.
I tried the 2 cell battery pack and get same reading.
I'm thinking of cutting the speaker wire.
Everything else seams to work transmitter binds and powers the servos, motor fine.
Any advice would be appreciated.