by BillGriffiths100 » Mon Jul 02, 2012 11:14 am
No 1/ If you shorted a wire as thin as the one connected to the "voltage detector" across the supply it would heat up like an electric fire because of the high current flow.
However in an application where there is a high resistance to the current flow ie the circuit and its components the current flow will be very low and the wire will be perfectly fine.
Its probably best to connect a sensor such as this to the esc wires at the connector end and use heat shrink to re-insulate the connection.
No 2/ As for your case carving, if you can open the module and temporarily move the electronics aside that would be helpful.
Probably the best but not the neatest way would be to use small wire cutters to nibble away the plastic,you could neaten it up with a knife or file afterwards, but it won't show anyway!
Compromising with out of control government is like living with a lion, sooner or later the bloody thing will eat you .
You accept the tyranny of the state when it's not being applied to you, when it is: it's too late.