by cynr100 » Tue Jul 24, 2012 11:33 am
Peter is right, this raises quite a few questions.
1/ Have you setup a model in the programming eg 4ch plane (can't remember if the Turnigy Firmware has templates), calibrated the stick movements and applied 100% throws.
2/ Is the servo okay and polarity is correct.
3/ Try connecting servos to ch1,2,3,4 at the same time, you may have been trying an unallocated channel.
Any chance you can post some pictures or a short vid on YouTube to show the setup and steps you have taken. It could be a complex or a simple fix, arriving at any solution with way to many possibilities is difficult with words only.
Dennis
Not enough time in the day for all my crazy ideas, I'm not slow, I'm just pacing myself