Hi,
Please add me to the list for a kit.
Thanks
Keith wrote:I got some of them 'saver', they are good...
S-rob wrote:Hi Guys.
If anyone has too much time on there hands & wants to etch there own board, heres a realy easy transfer method.
Print to Oracal 651 vinyl, then iron onto the PCB. (Sorry of this has allready been posted up)
http://www.electronics-lab.com/blog/?p=19912
http://www.youtube.com/watch?v=FtmJdCBj ... r_embedded
Some 'normal' waterproof Felt/marker pens are etch resistent, easy & cheap for touch ups before etching.
T3PRanch wrote:1 kit for me please.
Thurmond
- Parts used in backpack build video and BOP is not same, what is correct parts?
- 1N4001 or 1N4007, they are rated to 100v and 50v, is this correct part to use (i thought something around 12-15v would be correct) and which one is best to use/buy?
- 22uf 16v 1210smd, i cant find this part, the ones i find look different. The one i find is yellow and solder points look different. I find one that look same as used in video, but that's rated to 25v.
- What are the parts for audio? (1xresistor and 1xcapasitor? value?) and where do i connect microphone +/- ? (+ on last free pin and - on pin with all black?) what volt is microphone run on? The one i bought says 4-5v, can i use this?
I have bought one 5.8GHz 200mW VTx module(on back says, Tx5823-101016) from range video.
It says on their page that it will work with 5volt, can someone confirm this? If module need 5vdc should i then replace volt regulator to 5vdc on backpack instead of 3,3vdc listed/used? If i need to use the 5vdc regulator, do i need to do more modifications on backpack?
Return to DIY Projects and Hacks
Users browsing this forum: No registered users and 10 guests