Hi.
I have some questions regarding the Frsky DHT module with telemetry-
- I have bought turnigy9x and frsky DHT module. The module have a sort of servo plug on the side with 4-pins, GND,+5V,Txd and Rxd. Is it correct that the black part put on pins is there for no other reason than to protect the pins? And what are this pins for?
- I couldnt resist opening the plastic cover to reveal whats inside( thats when the black part fell off the four pins mentioned above).
I looked over the print and to my supprice i saw two parts soldered together (lower side of parts). On pcb the two parts have C50 and R50 printed to right of/under them(this is on same side as buzzer).
- I also see some open/missing parts on pcb they have number: same side as buzzer C65, C66, C67, C68, C70 and R22.
On the other side: upper left marked with letter K and A, there is also two free spots near the round part (right side of it) and its printed T1 between them. There is also 5 free holes on top of pcb and two right under them, there is also four free holes on bottom of card. What is all this used for?
Can someone confirm if all this is correct with DHT module? Someone have large pictures of both sides?
Ohh, i hope nothing is wrong with mine, but the two parts soldered together do worry me.
- Can someone tell me if its possible to get telemetry data on 9x screen. How is this done?
Roger