airfield x-6 transmitter conversion to buddy/trainer box

If you've been building electronic bits or modifying stuff you've bought then tell us all about it here. A good place to discuss the installation of 2.4GHz DIY modules too.

airfield x-6 transmitter conversion to buddy/trainer box

Postby rasrc » Fri Dec 21, 2012 6:07 pm

Well the subject pretty much sums up my question. I'm wanting to get others in the hobby and I'd like to use a trainer box to do it. Rather than go out and buy one (or in my case order one then wait a month for it to arrive) I thought why not convert an old transmitter. Can the stock x-6 be converted to a trainer box? I currently have this transmitter and a futaba 6ex. The plan is to make a cord that plugs into the 10 pin connection for the 2.4ghz module inside the x-6 (I couldn't believe it just plugs into the main board) and plug the other end into my trainer port on my 6ex.

Is this remotely possible? If I understand transmitters correctly I'm just wanting to take the signal that was being sent to the 2.4ghz module and redirecting it to my 6ex. Side note, the 6ex has an frsky module in it. Don't know if this matters.

Thanks in advance.
Ryan
rasrc
 
Posts: 1
Joined: Fri Dec 21, 2012 4:50 pm

Return to DIY Projects and Hacks

Who is online

Users browsing this forum: No registered users and 5 guests

cron