Charging HK 2.4ghz

Problems, experiences or just something to say about RC gear? Say it here.

Charging HK 2.4ghz

Postby Bruce8 » Tue Feb 05, 2013 10:59 pm

Hello again guys,
I have just got a hobbyking 2.4ghz v2 system and I just noticed a charging port on the side of the transmitter. This is another good addition to v2 of this radio along with frequency hopping. I have a JR and Futaba charging lead ( http://www.hobbyking.com/hobbyking/stor ... ing%20lead ) and I was wondering whether I could use either one to plug into the side of this transmitter. Is it safe to do so? I would be using Sanyo eneloops and a turnigy accucell 6 charger. If not should I just use a aa battery holder and connect the wires to my accucel?
By the way does anyone know what settings I need to put in for Sanyo 2000mah eneloops for the accucel 6?
Thanks!
Bruce8
 
Posts: 20
Joined: Wed Jan 02, 2013 11:43 am

Re: Charging HK 2.4ghz

Postby iflylilplanes » Wed Feb 06, 2013 11:12 am

You should charge at around 10% of C with 2000mah cells that will be 200mah or 0.2 on your charger, set your Aucell6 on delta peak charge. As to charging inside the transmitter, it depends on how much you trust Eneloop cells, in the the old days of Nicad cells the cells vented while charging giving off an acidic gas that caused corrosion on the ends of the cells, this meant that cells put into the standard battery holder could intermittently disconnect while in use whether this is the case with Eneloop I don't know. loose cell should be charged outside the transmitter so they can vent outside an enclosed space, and, if you want to charge inside the TX the cells will need to be welded together just like the JR and Futaba own packs. If you can't find ready made packs I can advise you of a company that can weld a pack up for you here in Sydney Australia, if you are not in OZ you will have to find a manufacturer your self.
Many Thanks,

Dave W.


Dead Stick Glide Distance: Half the distance from the airplane to the nearest emergency landing field.
User avatar
iflylilplanes
 
Posts: 91
Joined: Thu May 24, 2012 11:14 am
Location: Sydney, Australia

Re: Charging HK 2.4ghz

Postby Bruce8 » Wed Feb 06, 2013 6:35 pm

Thanks for the advice! I think I will just use a Futaba battery case that I have lying around, put in the batteries and then charge them from there.
Bruce8
 
Posts: 20
Joined: Wed Jan 02, 2013 11:43 am


Return to Radios and Servos

Who is online

Users browsing this forum: No registered users and 2 guests

cron