I have a Turnigy 9X V2. Rx is CR8D. I can't get ch 5-8 to do anything. I have heard that you have to enable , activate , turn on. these channels. Can someone tell me how to do this.
Is there a basic setup manual for us that don't have the now how to feger out how to set this TX up.
Thank you all
Turnigy 9X Enable Ch 5-8
4 posts
• Page 1 of 1
Turnigy 9X Enable Ch 5-8
by dalefhome » Mon Jul 12, 2010 6:54 pm
- dalefhome
- Posts: 7
- Joined: Mon Jul 12, 2010 6:27 pm
Re: Turnigy 9X Enable Ch 5-8
by RCModelReviews » Mon Jul 12, 2010 8:14 pm
I'm about half-way through my 9X manual and video series. It will cover these points (in both firmware revisions) so if you can wait a week or so I'll have all the answers for you.
RCModelReviews.com, just the facts.
-
RCModelReviews - Posts: 2120
- Joined: Tue May 04, 2010 3:40 am
Re: Turnigy 9X Enable Ch 5-8
by dalefhome » Mon Jul 12, 2010 8:22 pm
Thank you for the fast reply.
I look forward to you manual and videos. I'm sure all the answers will be there.
In the mean time if there is someone that can tell me how to turn on Channels 5-8, I can continue with my build.
I look forward to you manual and videos. I'm sure all the answers will be there.
In the mean time if there is someone that can tell me how to turn on Channels 5-8, I can continue with my build.
- dalefhome
- Posts: 7
- Joined: Mon Jul 12, 2010 6:27 pm
Re: Turnigy 9X Enable Ch 5-8
by rwsams » Tue Jul 20, 2010 4:37 pm
RC,
Can't wait to see your manual and videos!
More thanks. Donation on the way.
Can't wait to see your manual and videos!
More thanks. Donation on the way.
- rwsams
- Posts: 5
- Joined: Thu Jun 24, 2010 6:41 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 17 guests