Hello everybody,
Have a nice day, i am a new here today ..but old on Mr.Bruce's youtube :)..
My problem guys is that i set the old DIY V8HT module to my Turnigy 9X like what Mr.Bruce did ..
Also i bought Delta 8 Multi-Protocol Receiver for using it on my upgraded turnigy 9x..
The problem is, it is not binding,, Although the TX and Rx goes to there binding mode successfully. But when switching both off then first switch on the TX then RX .. Rx will flash green ..refer to its manual this means there is no signal ..
So, Does anybody have a solution , suggestion or idea..
Note, i also open the TX to see if there any losen wire but looks fine.. and tried to bind it with a distance but also not bind ..
Sorry for my long written..
Thank you.
Best Regards